WE ACCEPT
All repairs should be performed by authorized technicians. This information is provided as a courtesy for our customer. Never troubleshoot a pump that has pressure in it.
| Problem | Cause | Solution |
| Power switch is on and sprayer is plugged in, but motor does not run, and pump does not cycle. | Pressure is set at zero pressure. | Turn pressure control knob clockwise to increase pressure setting. |
| Motor or control is damaged | see Motor Does Not Operate | |
| Electrical outlet is not providing power | Try a different outlet, reset circuit breaker | |
| Extension cord damaged | Replace with approved cord | |
| Sprayer cord is damaged | Check for broken insulation or wires | |
| Paint is frozen or hardened in pump | see Motor Does Not Operate | |
| Pump does not prime | Spray-Prime/Drain valve is in spray position | Turn valve to prime position |
| Inlet screen is clogged or suction tube is not immersed | Replace inlet screen and make sure suction tube is at bottom of pail | |
| Balls check valve are stuck, or check valves are damaged | Clean or replace check valves | |
| Suction tube is leaking | Tighten suction tube connections or replace tube | |
| Spray gun stopped spraying | Spray tip is plugged | Unplug spray tip |