WE ACCEPT
p1
| Problem | Cause | Solution |
| Pump cycles but does not build pressure | Pump is not primed | Prime pump |
| Inlet screen clogged or suction tube not immersed | Clean or replace screen and immerse tube | |
| Paint pail is empty | Refill paint pail and reprime pump | |
| Suction tube is leaking | Tighten suction tube or replace if leaking | |
| Pump check valves are dirty or damaged | Clean or replace check valves | |
| Spray-prime/drain valve is worn or obstructed | Clean drain valve or replace if worn | |
| Pump cycles but paint only dribbles or spurts when spray gun is triggered | Pressure is set too low | Slowly turn pressure control knob to increase pressure setting to check if sprayer develops more pressure |
| Spray tip is clogged | Unplug tip | |
| Fluid filter is clogged | Clean or replace filter | |
| Spray gun fluid filter is clogged | Replace gun filter | |
| Spray pattern
leaving stripes
|
Tip is worn | Replace tip |